My advice is try using existing documents with Libre office. You can install it on windows as well.
I use Linux for over twenty years now and installed windows on a vm last week to Wirte my resume. Libre office is fine, you run into problems when opening and editing existing ms office documents. At least that is my experience.
But give Libre office on windows a shot, see if you like it.
https://github.com/toverainc/willow
They even have a dedicated piece of hardware for it.
Yes and no. If your isp is still providing unencrypted DNS for you, then they can still see the domain name you’re visiting.
Look into vlan.
Basically allows you to have different subnets rubbing on a physical network card.
It is possible what you want to do and not that complicated.
Reolink ist the way to go. I think only the battery powered ones don’t have onvif. Otherwise the poe cameras all support onvif and are generally of very good quality. Plug it in and of you go. EDIT: Forgot to mention: You can configure the camera via the web interface, so no need for an app. I’m using the 820 at the moment, but I’m planning to get the new trackmix camera, these look really good.
It is absolutely possible to dual boot from a single harddrive. Don’t know about fedora, but the Ubuntu installer has taken care of that for ages now. Yes, it can fuck your windows install initially, but that is normally reversible.
If you don’t know, a computer uses so called partitions and not the hard drive directly. Think of them as folders. Normally you have one partition which holds the bootloader information (one or two OS, or more) and then a partition for each OS. A little Programm after Turning on the computer let’s you choose which OS you want to boot.
A lone Linux installation often has three partitions on one harddrive. One boot Partition, one for the OS and one for the home directory of all users. This way you can reinstall the OS without loosing your home directory.
Thanks. This definitely goes onto the pile of things I’ll build at the new house.
Not OP, but most people are using load sensors under the bed frame with an esp or raspberry.
Thanks for posting, hadn’t heard about Ubuntu core. Reads promising at least…
there are basically endless possibilities I’d say.
That being said, I would recommend jellyfin over emby.
Easiest route you could go is setup a systemd timer which runs every 5 mins, pings an ip and write the result into a logfile. that way you have a timestamp for the problem start without going all out with monitoring.
Good luck!
Since you’re not really sure what the issue is, check all the logfiles around the time the problem starts. maybe you’ll see a service stopping or starting.
This might not be applicable to your use case, but maybe it helps.
Couple of years ago I had a problem where ONE windows laptop was unable to access the internet. Sometimes it would work right away, sometimes it took 1 or 2 reboots, sometimes the damn thing wouldn’t budge.
lo and behold, it turns out the windows laptop was assigned a DHCP address that one linksys router had as a static ip. Why that resulted in a sporadic error and not a constant one I’ll never know.
So next time you have this issue, rip out the network cable from the server and try to ping the ip the server is supposed to have.
Other than that, check the journal if something start to pop up around the time you experience the problem.
catch two birds with one stone and make the spam about reddit alternatives.
Are you using groups with snapcast? Lat time I used it that was a major pain in the ass and made me switch to squeezebox.
Afair the groups were named on the fly and you couldn’t create static ones (downstairs, house for example)
EDIT: Found one of the threads and it is still open. https://github.com/badaix/snapcast/issues/308 Seems there is a workaround for home assistant, but that doesn’t look like it is really stable so to speak. I guess I’ll stick with squeezebox for now, the sync feature is good enough for me.
Thanks, ill try it out later. As someone else suggested already, maybe this is of interest to the devs of lemmy As well.
The fact that the ccc uses matrix as their official chat “app” doesn’t imply that it is inherently insecure I would say.